Tiantai, Your honest brewery equipment builder!
7HL micro Brite Beer Tank Introduction
Beer will be brewing in fermentation tanks for about one week.
After an initial or primary fermentation, beer is conditioned, matured or aged, in one of several ways,which can take from 2 to 4 weeks, several months, or several years, depending on the brewer's intention for the beer. The beer is usually transferred into a second container, so that it is no longer exposed to the dead yeast and other debris (also known as "trub") that have settled to the bottom of the primary fermenter. This prevents the formation of unwanted flavours and harmful compounds such as acetylaldehydes. During secondary fermentation, most of the remaining yeast will settle to the bottom of the second fermenter, yielding a less hazy product.
7HL micro Brite Beer Tanks are often also called serving tanks, tax determination tanks or clear beer tanks (=CBTs), 7HL micro Brite Beer Tanks (=BBTs) or maturation or conditioning tanks. These tanks are used for the storage of the beer prior to being served or packaged. Depending on their application the beer serving tanks can be glycol jacketed or can be located in a cold room.For brewpubs serving is often done by pumping or pressurizing the beer toward the serving location.
7HL micro Brite Beer Tank Specification
Tank Capacity: 7HL (+25% Headspace minimum)
7HL micro Brite Beer Tank Configuration
Design pressure 45 psi (3bar); working pressure 25psi (1bar)
4 stainless steel legs with leveling footpads
Interior shell: 254 stainless steel, thickness 3mm
Exterior shell: 254 stainless steel, thickness 2mm
Interior and exterior finish bright polish to 0.4～0.6 μm, hygiene surface
All Interior welds ground to a smooth0.4～0.6μm sanitary finish
Flanged and dished head top and bottom
25% headspace unless a different volume is requested
Combined drain extensions and beer port are standard
Top manway or side manway door
Dual zone in sidewall and bottom dimple cooling jacket with glycol inlet and outlet
Polyurethane insulation thickness 80mm for cooling jacket on side and bottom
Non welding CIP arm and rotating 360 degree reach spray ball
Carbonation system with micron stone
Solenoid valve, pressure relief valve (safe valve) are standard.
Temperature sensor well
All clamps and gaskets to attach all accessories
Tank complete with piping, fittings, sanitary valves and all parts.
If you are would like to change, add, remove or modify any part of the tanks, we can accommodate that. Specific fitting sizes, changes and locations will be set during the design process after a deposit is taken.
REQUEST A QUOTE
Product Name: 7HL micro Brite Beer Tank